However, Campus Component Pvt. Device Manager After Installation on Windows 7 In order to look at a register or variable, right-click on the expression and select Add to Watch. Using IAR to Debug an Application For this application note example, activate the gpio project from the Workspace tab and ensure that the project settings described above have been properly configured. The default debug settings will automatically place a breakpoint at the main function Figure 5. The Digi logo is a registered trademark.
|Date Added:||22 December 2014|
|File Size:||67.95 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The BTUpdater application is automatically installed. The adapter provides an RJ11 connector with the signals to communicate with all 1-Wire and ibutton. To view the source code for the project, double-click on the file gpio. Start display at page:. All Lambda devices Lambda10B. Refer to Image A. The projects are now ready to be compiled, loaded, and debugged on the EV Kit.
The adapter is powered directly over the USB cable. The default debug settings will automatically place a breakpoint at the main function Figure 5. The Digi logo is a registered trademark. And you are familiar with their utag. In order to look at a register or variable, right-click on the expression and select Add to Watch.
MAXQ USB-to-JTAG/1-Wire Adapter Evaluates: MAXQ Microcontrollers – PDF
Text in bold refers to items directly from the EV kit software. Making Programmer and Basic target.
The adapter has two connectors. Hardware Update Wizard Install from Disk 8. The MAXQ includes a number of important features: Midland BT Updater After you downloaded the BT Updater setup application from the web site, double click on utag and follow the installation procedure.
MAXQ USB-to-JTAG/1-Wire Adapter Evaluates: MAXQ Microcontrollers
The first four pins are wired to these LEDs and can be manipulated by the software. This action automatically compiles the source code and loads it onto the MAXQ Renesas Technology America Inc. The Digi logo is a registered trademark More information. If a device of the same type has been installed on your machine before and the drivers. Use the System Device Manager to verify the com port setting. This will allow computer More information.
The IAR software allows the user to view variable and register values while debugging. Installation of the USB driver 1 2.
Getting Started with the MAXQ Evaluation Kit – Electronic Products
The default Sysclk is 12MHz, making the timer raise its flag every second Figure 7. The BTUpdater application is automatically installed More information.
For this application note, the jumpers should be configured to match the default settings, as shown in Table 1. System Requirements More information. Wilsonville, OR This document.