MSI 6741 DRIVER

Floppy Disk Drive Connector: You can barely see the golden finger if the module is properly inserted in the socket. Position the heatsink onto the retention mechanism. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. You can clear CMOS by shorting pin while the system is off. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper.

Uploader: Tajinn
Date Added: 13 January 2008
File Size: 66.53 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 86362
Price: Free* [*Free Regsitration Required]

Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions.

You can clear CMOS mmsi shorting pin while the system is off. Then push it in until the golden finger on the memory module is deeply inserted in the socket.

It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. You can plug the USB device directly into the connector. It supports a three-pin head connector.

Always consult the vendors for proper CPU cooling fan. The third PCI slot supports 2 master devices. Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused.

  APACER MOUSE M811 DRIVER DOWNLOAD

MSI MS-6741 Manuals

If the 67411 is correctly installed, the pins should be completely embedded into the socket and can not be seen. Press the two levers down to fasten Press down ,si fan until its four clips get wedged in the holes of the retention mechanism.

Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. Follow the instructions below to clear the data: IDE1 can connect a Master and a Slave drive.

The gold arrow should point towards the lever pivot. Make sure to raise the lever up to a 90degree angle. It’s a community-based project which helps to repair anything.

MSI K8MM-ILSR – motherboard – micro ATX – Socket 754 – K8M800 Series

While doing the installation, be careful in holding the components and follow the installation procedures. Please turn off the power and unplug the power cord before installing the CPU. Locate the CPU and its retention mechanism msk the motherboard.

Meanwhile, read the documentation for the expansion card to make any necessary ksi or software settings for the expansion card, such as jumpers, switches or BIOS configuration. The connector location and pin assignments are as follows: When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating.

  ARTSIGN AS1360 DRIVER DOWNLOAD

MS MOTHERBOARD | Emachines MS K8T Motherboard

You must configure second hard drive to Slave mode by setting nsi jumper accordingly. You can barely see the golden finger if the module is properly inserted in the socket.

If you do not find the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control.

You can install either single- or double-sided modules in any order to meet your own needs. Then push down the power supply firmly into the connector.

MSI MS Specifications |

Line In is used for external CD player, Tape player, or other audio devices. Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating. Floppy Disk Drive Connector: Position the heatsink onto the retention mechanism.

J9 Optional You can connect a joystick or game pad to this connector.